After market camera
-
- Messaggi: 3
- Iscritto il: mercoledì 17 giugno 2020, 16:14
- Località: Iași, Romania
Hello! First of all sorry for non Italian language. I have searched about this subject on forum but I didn't see any result and I hope this will not be deleted.
I want to install a rear camera on my 5 inch screen navigation. The navigation wasn't came with my car. I mounted it one year later, and doesn't have a camera.
Are any possibilities to install a after market camera on it? Is someone here who have the scheme of jack that connect navigation with car? I think if I will find the pins that are responsible with rear camera I will be able to install the camera.
Thank in advice for replying!
I want to install a rear camera on my 5 inch screen navigation. The navigation wasn't came with my car. I mounted it one year later, and doesn't have a camera.
Are any possibilities to install a after market camera on it? Is someone here who have the scheme of jack that connect navigation with car? I think if I will find the pins that are responsible with rear camera I will be able to install the camera.
Thank in advice for replying!
-
- Utente
- Messaggi: 11
- Iscritto il: domenica 17 novembre 2019, 22:41
- Località: Como
Hi there,
The orginal camera is connected with the pins 31, 32, 33 in the orginal plug.
31 - signal from camera
32 - GND to camera
33 - Shield
I believe you can connect an aftersales camera to the same pins.
If I'm not wrong, if you have a newer firmware on your uconnect, you need to plug a NTSC camera, PAL Is not supported anymore.
The orginal camera is connected with the pins 31, 32, 33 in the orginal plug.
31 - signal from camera
32 - GND to camera
33 - Shield
I believe you can connect an aftersales camera to the same pins.
If I'm not wrong, if you have a newer firmware on your uconnect, you need to plug a NTSC camera, PAL Is not supported anymore.
-
- Utente
- Messaggi: 6
- Iscritto il: sabato 30 gennaio 2021, 20:25
- Località: napoli
Çok teşekkür ederimIlcech ha scritto: ↑lunedì 29 giugno 2020, 21:46 Hi there,
The orginal camera is connected with the pins 31, 32, 33 in the orginal plug.
31 - signal from camera
32 - GND to camera
33 - Shield
I believe you can connect an aftersales camera to the same pins.
If I'm not wrong, if you have a newer firmware on your uconnect, you need to plug a NTSC camera, PAL Is not supported anymore.